Removing And Installing The Door Panels; Troubleshooting; Troubleshooting Table - Bosch HBA41B2 1J Series Instruction Manual

:
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
Open the oven door fully.
1.
Fold up the two locking levers on the left and right (figure A).
2.
Close the oven door as far as the limit stop. With both hands,
3.
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
$
Attaching the door
Reattach the oven door in the reverse sequence to removal.
When attaching the oven door, ensure that both hinges are
1.
inserted straight into the opening (figure A).
The notch on the hinge must engage on both sides (figure B).
2.
$

Troubleshooting

Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.

Troubleshooting table

Fault Possible cause Solution/advice
The oven does The fuse has
not work. blown.
Power cut.
%
%
Check the condition of the
fuse in the fuse box.
Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
Fold back both locking levers (figure C). Close the oven
3.
door.
&
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the after­sales service.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
Detach the oven door and lay on a cloth with the handle
1.
facing down.
Unscrew the cover on top of the oven door. To do this, undo
2.
the left and right screws (figure A).
Lift the panel, and pull it up and out (figure B).
3.
$
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper.
The glass could be damaged.
Insert the panel diagonally towards the back. The smooth
4.
surface must face outwards.
Put the cover back in place and screw it on.
5.
Attach the oven door.
6.
Do not use the oven again until the panels have been
correctly fitted.
Fault Possible cause Solution/advice
The oven does The timer is at
not heat up. the
minimum
ng.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
%
Turn the timer to the
setting.
>
setti
Ú
11