Technics SD-S947 Operating Instructions Manual page 41

To record selected tracks
I _ J Press DECK 1/2 to select the
Deck 1.
therecord_g standby m ode.)
to record.
It is also possible to change the playback tape at this
time.
_ (Recording will resume.
When new recordings are made on a pre-recorded tape, all sounds
recorded on that portion of the tape are automatically erased. To
erase a tape without making a new recording, follow the steps
below.
4 123
J ----,I
_1 II F
©
I..I
• Load tha tabe to be erased into Deck 2.
• Set the input source on the amplifier to "TAPE MONITOR" posi-
tion.
...... ........ .................................
Press DOLBY NR so that the
Dolby NR indicators ("B" and
Pres_ DOLBY NR so that the
Dolby NR indicator is off.
To cut unwanted parts during
recording
(F_ recording.
Deck 2, which was recording, will enter
_) the pause mode, and Deck 1 will contin-
ue playback.
(If you were recording at hi-speed, Deck
1 will change to normal speed while
Deck 2 is on pause, but will return to hi-
speed when you resume recording.)
. to record]
_:'-I • I _ I Pr,=either
'4 or k, corresponding
tO
the side of the tape side indicator which
(Deck 2 will resume recording.)
m
For your reference:
• The Dolby effect will be reco'rcle_las they are on the tape being
played back.
• Because the signal being recorded from Deck I onto Deck 2 does
not pass through the amplifier, it is possible to change the seffing
of the amplifier's input selector during recording in order to listen
to some other sound source.
When recording with the recording speed set to double speed,
noise interference may be recorded onto the tape if there is a televi-
sion set nearby, so make the recording in a location separated from
the television set or switch off the television set during recording.'
'""_ ......... _;_'R'_'v_'i_s_'_i_v'i_';_ ...........
select the desired reverse
m__oode.
_,"\_ .,--- : To erase one side of the tape.
",,-J _;_, C_ : To erase both sides of the
tape.
(The unit will be in the recording standby
"_ mode.)
erasing the tape.
_:To erase the forward side of the
tape.
'4: To erase the reverse side of the
tape.
To erase both sides of the tape, be sure
to press the _ button.
41