Technics SD-S947 Operating Instructions Manual page 24

Table of Contents

Advertisement

Setting/Removing
discs
Special
notes
• You can set discs in the slots and remove them too, while playing
discs.
• Never set a disc in the slot of the disc being I:dayed.
• Sometimes the front panel cannot be opened while a disc is play-
ing. It is a question of time. In such case, wait until you can open
it.
How
to set discs
1. Pulling gently from both ends, open the front
panel.
Magnetic latch
_
,"
I
.
• Except when seffing or removing discs,
keep hands out of the
changer _e
open. You could injure yourself if somehow
en_m-
gled in the internal mechanism.
• Keep cassette tapes away from the magnetic latches.
display. Remove the disc that doesn't belong in the slot and press
the stop button.
• Do not open the front panel while the changer is changing discs.
Note
• Set discs with the label facing to the righL
• Never load more than one disc in any given slot.
4. Gently close the front panel.
ff you leave the front panel open while a disc is in play, when the
disc is over, the changer will stop.
How
to remove
discs
1. Open the front panel.
2. Slide the loader carriage to the slot you want
2. Slide the loader carriage to the slot you wanL
You can read the numbers between the prongs
as shown below.
Disc slots
3. Press the eject button on the loader carriage.
t
Loader carriage
Eject button
.o.
I
Slot No. 0 (SINGLE) is reserved for single disc play.
3. Set the disc on the loader and flip the loader
upwards.
Disc
Label side
Rip this part upward.
Cautions
4
• Do not use 3" (8 cm) dis_ fitted with expaVnderrings. Expander
rings could damage the disc slots.
%Do not use cleaningdiscs, discs with stickers on the label side or
warped discs. All of these could damage your changer.
• DO not put anything other than discs in the changer.
• Do not set a disc in the slot of the disc being played (slot flashes).
The disc in play is returned to its slot when finished, ff two discs
somehow jam the slot, one or beth could be damaged. When this
.... _ _J_pens, the message "TAKE OUT" will appear on the
How
to know
what
disc
is in what
slot
Your changer comes with a notebook-like binder (liner notes orga-
nizer) in which you can keep your CD liners. There are also adhe-
sive numbers for indicating slot numbers in the binder. This is a
convenient way to keep track of what disc is in what slot.
Put two liners back-to-beck inside each pocket, as shown above.
liner
Adhesive.
_
/
Binder
24
-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sd-s747Sd-s937Sd-s737

Table of Contents