Mhz Frequency Step; Changes In Displayed Frequencies - Kenwood TH-79A Instruction Manual

5 Press [STEP] to store the selected value and exit.
- VFO mode is restored.
Note:
+ The step size can be set separately for the VFO, Call channel,
and memory channels.
+ When using the UHF/UHF configuration, the frequency steps of
5 kHz and 15 kHz cannot be selected on the A band (upper
Display). Only 10 kHz, 20 kHz, 12.5 kHz, and 25 kHz can be
selected.
Mm 1 MHz Frequency Step
The 1 MHz Step function allows rapid freguency
excursions up or down the band with a minimum of
key strokes.
1 Press [BAND] to select the Operating band.
2 Press [VFO] to select VFO mode.
3 Press [MHz].
4 Turn the ENC control to select the desired MHz
digit.
5 Press [MHz] to restore the previous freguency
step.
Note: 1 MHz Step does not work in Memory Recall or Call
channel modes.
an
M Changes in Displayed Frequencies
Changing between step sizes may result ina
change of the displayed frequency. When a change
occurs, and by how much, is shown in the
accompanying charts.
5, 10, 15, or 20 kHz Step 12.5 or 25 kHz Step
Betore After
(10 kHz/ 1 kHz Digits)
(10 kHz/ 1 kHz Digits)
00, 05, 10, 15
20, 25, 30, 35
40, 45, 50, 55
60, 65, 70, 75, 80, 85, 90, 95
12.5, or 25 kHz Step— 5, 10, 15, or 20 kHz Step
Before After
(10 kHz/ 1 kHz/ 500 Hz Digits). | (10 kHz/ 1 kHz Digits)