Table of Contents
Advertisement
6.7
Fume extraction
Fume extraction must be arranged in such a way as to provide complete
extraction of all products of combustion to an area outside the living area.
The flue system must slope in an upward direction in order to avoid a
build-up of condensation.
6.7.1
Fitting the fume flue in the upper ventilation grille
4. Put cap (B) on flue pipe (C).
5. Insert extractor insert (A) into ventilation grille (D).
This type of fume extraction allows use a winter cover.
An installation that is not carried out by qualified persons causes a
reduction in the cooling capacity and will jeopardize the
manufacturer's guarantee.
min. 10 mm
max. 20 mm
22
1. Connect T-piece (E) to
adaptor (F) or flue pipe
(K) as required and affix
with screw (G). Ensure
that heat baffle (H) is
lodged in the correct
position.
2. Insert flue pipe with cover
plate (C) through the
appropriate aperture in
frame (I) and connect to
T-piece (E). If necessary,
shorten flue pipe (C) to
the required length.
3. Insert ventilation grille
(D) into mounting frame
(I) and fasten, using the
locking handle on the left
of the grille.
Advertisement
Table of Contents
