Sony CDP-991 Operating Instructions Manual page 30

Fading Out at the Desired Time — Time Fade
You can have the play fade out at the end by designating the play duration. Once
time fade is set, it functions twice for editing both sides of the tape. You can
change discs without canceling this function.
This function cannot be conducted on multi-disc program or when the DIGITAL
OUT (OPTICAL) is being used for connections.
Setting the Time Fade and Playing
FADER 2-b)
1 Press EDIT/TIME FADE three times during
stop or once in the pause mode.
et
rue and 2.] are displayed in the window.
Note
Avoid pressing @ (Stop) while programmed selections are not
played. Otherwise, they will be erased.
2 Specify desired fade time.
a) When you specify a commercially
available tape length:
Each time you press Pl, the display
changes to give you the following duration.
HALF DISC C-46 —+ C54 + C60
(23.00 min.) (27.00 min.) (30.00 min.)
S2ees - C9 < C74 ase
(45.00 min.) (37.00 min.)
By pressing #4, you can reverse the above
cycle.
With HALF DISC, the playing time is set to
half of the total playing time.
Example: a 54 minute tape
o
L Isis
ale ole alo
|
i=) a il BO
b) When you specify a free yes length:
Use numeric buttons ([1}- {10} ).
Press [10] for "0".
You need not press keys for seconds, unless
required.
Example: a 46 minute tape (23 minutes per
side)
ee AER ee
3 To start play, press >.
oe
\ >
After the designated time, play fades out and
pauses. Tape side B lights up.
Press or El to resume playing for other side
of the tape.
If you press FADER, fade in will start. When the
play fades out for the second time, the player
pauses and the time fade function is canceled.
30
When playback of a disc ended before the designated
playing time
The time fade function will remain effective even for a new
disc(s) added for the remaining playing time originally
designated, and the fade out starts in accordance with the
initially set fade time.
To cancel time fade
Time fade will be canceled when
- EDIT/TIME FADE is pressed once again.
~ </> is pressed during play.
To display the time remaining until the time set
Press TIME/MEMO (or TIME on the remote commander) twice.