Epson PowerLite Pro Cinema 6040UB Quick Setup page 2

Adjust the image
1
Press the Pattern button on the remote control to display a test pattern.
2
To raise the image or correct a tilted image, adjust the front feet as
shown below.
3
Press the Lens button on the remote control and use the
to focus the image.
4
Press the Lens button on the remote control again and use the
buttons to reduce or enlarge the image.
5
Press the Lens button on the remote control again and use the
, and buttons to reposition the image.
6
If your image looks like
projector to correct this.
Note: Using the keystone adjustment can affect the size and effective
resolution of your image. If possible, change the position of your
projector to eliminate the keystone effect and use the lens shift option
to position the image as necessary.
7
Press Esc to exit.
Viewing 3D images
and buttons
To view 3D content, you must first connect a 3D-compatible video device to
one of the HDMI ports on your projector. You also need a pair of Epson
number V12H548006) or Epson-compatible RF 3D active shutter glasses.
1
Turn on and begin playback on the 3D-compatible video device.
Note: Make sure you set the video device to play content in 3D mode.
2
Slide the power switch on your 3D glasses to the On position.
and
Note: If the glasses don't automatically display 3D content, you may need
to pair them with the projector. Move the glasses within 10 feet (3 m) of the
projector, then press and hold the Pairing button on the 3D glasses for at
least 3 seconds. The status light on the glasses will alternately flash green and
, ,
red, then remain green for 10 seconds if pairing is successful.
You can also automatically convert 2D HDMI content to 3D. To enable the
2D-to-3D Conversion option, press the Menu button on the projector or
remote control. Select Signal and press Enter, then select 3D Setup and
press Enter. Select 2D-to-3D Conversion and press Enter. Select the Weak,
Medium, or Strong setting, then press Enter.
See the online User's Guide for more information on adjusting 3D images.
or , you can use the buttons on the
(part
®