Rear Power Take-Off - International Harvester Company INTERNATIONAL Cub Cadet 73 Operator's Manual

REAR POWER TAKE-OFF
International Cub Cadet 73, 106 and 126 Tractors
AU-)502a
ItIusK ISA
Intemotional Cub Cod«t 106 ond 126 Tractors
1» Shifter rod
2s Power takt«off guard
3, Grease fitting
2« Depress the pedal and move the trans*
mission gearshift lever to the neutral position
lllusta 15
International Cub Codet 73 Tracto
3, On the International Cub Cadet 73 Tractor: Press
down
on
the shifter rod
(lllust» 15)
and move it
rearward to the engaged position. Then release
the shifter rod and allow it to lock in place.
If your tractor is equipped with a rear power
take*o£f, the following instructions should be
carefully studied and followed.
On the International Cub Codet 106 and 126 Troctors:
Move the shifter lever
{Illust. 15A)
forward to the
engaged position.
The rear power take-off is started and
stopped by the same engine clutch as the trac
tor. Be sure to disengage the engine clutch
before moving the power take-off shifter rod
(Illust. 15) or shifter lever (Illust. ISA).
4. Move the throttle lever toward the
position and slowly release the pedal.
Caution!
The shifter rod should always be in
the disengaged (forward) position or the shifter
lever in the disengaged (rearward) position
when the power take-off is not in use. Always
cover the power take-off exposed shaft with
the guard when the power take-off is not being
used.
OPERATING THE REAR POWER TAKE-OFF WITH
TRACTOR IN MOTION
Follow steps I thru 3 outlined above. Keep
the pedal depressed, move the transmission
gearshift lever to the speed desired and ad¬
vance the throttle lever. Slowly release the
clutch pedal. This will start the tractor in
motion with the power take-off in operation.
OPERATING THE REAR POWER TAKE-OFF WITH THE
TRACTOR STANDING STILL
1. Move the throttle lever back to the
SLOW^* speed.
15