Energizer EZPE20V4A User Manual page 12

Battery capacity indicator
There are battery capacity indicators on the battery pack; you can check the capacity status of the battery if
you press the button. Before using the machine, please press
full enough for properly working.
The 3 LEDs will show the capacity level of the battery.
WARNING: Before making any adjustments ensure the drill is switched off with the direction
of rotation selector in the center position
1 ) Remove the battery: press the battery release latch in and at the same time pull the battery pack off.
2 ) To insert the battery, push the battery pack onto the contacts of the tool.
5.2 ASSEMBLY AN ABRASIVE SHEET
Warning: Remove the battery from the tool before assembly and setting!
Choose an appropriate grit sheet according to the type of work to be done.
Before mounting a new abrasive sheet, remove dust and dirt from the sanding pad with a brush.
The surface of the sanding plate is provided with a self-gripping coating, which makes it possible to quickly
and easily attach abrasive sheets with self-gripping system. Apply an abrasive sheet to the bottom surface
of the sanding pad with moderate pressure.
To change the sanding sheet, peel off the used sheet, discard the sanding pad from the dust and apply a
new sheet to the tray. When renewing, be sure to align the holes in the paper with the holes in the sanding
tray to ensure good dust evacuation.
When the sanding pad is worn, it no longer has a firm grip on the sanding sheet, so it must be replaced.
5.3 ASSEMBLY OF A DUST COLLECTOR
Use a dust extraction device suitable for the material.
Insert the connection adapter into the outlet of the sander.
For the suction of dust particularly harmful to health, carcinogenic or dry, use specific vacuums.
After completing the work, empty the dust collection bin.
5.4 SWITCHING ON/OFF
- Switching on: Put the on / off switch (1) in position [ I ] .
- Switching off: Set the on / off switch (1) to position [ 0 ] .
5.5 INSTRUCTIONS OF USE
For rough sanding, use a coarse grit sheet. Lightly squeeze the sander to allow it to run at a higher speed for
better material removal.
For finishing sanding, use a fine grit sanding sheet. By varying the pressure slightly or changing the speed of
rotation, you can reduce the speed of the sanding plate while maintaining the eccentric movement. Guide
the sander to the workpiece using circular motions or alternating longitudinal or transverse passes.
An abrasive sheet with which to sand a metal should not be used for other materials.
For the polishing of varnished surfaces, it is possible to provide the sander with appropriate sanding is such
as felt sheepskin disc or polishing sponge. Choose a low speed to prevent excessive heating of the surface.
Let the tool to run at idling speed for a few minutes after a strong load to cool the power tool.
Take care to ensure sufficient dust extraction during operation.
switch trigger to check if the battery is
the
12