Operation - Energizer EZPE20V4A User Manual

Information
The declared vibration total value has been measured in accordance with a standard test method

and may be used for comparing one tool with another .
The declared vibration total value may also be used in a preliminary assessment of exposure.

Warning
The vibration emission during actual use of the power tool can differ from the declared total value

depending on the ways in which the tool is used .
Nee d to identify safety measures to protect the operator that are based on an estimation of

exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger time).
 Wear hearing protection.

5. OPERATION

5.1 CHARGING THE BATTERY PACK
IMPORTANT: The battery pack is not fully charged at the factory.
Before attempting to charge them, thoroughly read all of the safety instructions.
1) Make sure the correct charger is used to recharge the battery .
2) Insert the charger into 220-240V~, 50-60Hz outlet. The indicator light (5) become s red to show
the power is connected.
3) Insert the battery (7) into the slot of charger (6). Make sure the contact with the charger is correct.
4) The indicator light (5) will become green and flash when charging.
5) When fully charged , t he indicator light (5) will turn solid green.
6) Frequently monitor the charger and battery pack while connected.
7) Unplug the charger and disconnect it from the battery pack when finished.
8) Allow the battery pack to cool completely before using it.
9) Store the charger and battery pack indoors, out of reach of children.
N OTE : If the battery does not fit properly, disconnect it and confirm that the battery
pack is the correct model for this charger as shown on the specification chart. Do not
charge any other battery pack or any battery pack that does not securely fit the charger.
NOTE: If battery is hot after continuous use in the tool, allow it to cool down to room
temperature before charging. This will extend the life of your batteries.
NOTE: Remove battery pack from charger us ing your thumb or fingers to press the
battery's release button in and to pull the battery pack off at the same time.
11