Brother PT-E800T User Manual page 19

Printing Using the Computer
Cutting Options
The cutting options allow you to specify how the item is fed and cut when it is printed. Use the printer driver
to select the cutting option for tubes or tape when printing from the computer using the application. Set the
cutting line (dotted or solid line) for tubes using [Device Settings] in the [Tube Settings] tab in the "Printer
Setting Tool".
See the following table for a list of all available settings:
Tube Cut Option Table
Cut Option
No Half Cut The tubes are fully cut only after the last tube is printed.
The tubes are half cut in the margin before the first tube is
Half Cut printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
A dotted line is printed in the margin before the first tube is
Dot printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
A solid line is printed in the margin before the first tube is
Line printed and after each of the remaining tubes is printed. The
tubes are fully cut after the last tube is printed.
Note
• You can use the tube half-cut adjuster of the P-touch to adjust the depth of half cuts to one of three
settings.
• If the tube is jammed or not cut completely, use the
completely. Press and hold the button for 2 to 10 seconds until the
being lit in green to flashing in green, and then release it. The tube will be cut when the button is released.
Description
(Feed and Cut) button to manually cut the tube
Image
(Power) indicator changes from
2
2
12