Vertical Steam Function; How Can I Replenish The Water During Operation; When You Have Finished; Cleaning - BOMANN DBS 6033 CB Instruction Manual

CAUTION: Initial Use:
9. Turn the steam flow controller to " MAX ". Now press
the steam button for at least 20 seconds or until
the steam begins to discharge from the iron soleplate.
This time is needed for the steam to reach the iron. A
slightly louder noise of the pump is normal with this.
CAUTION:
• A high temperature is needed to iron with steam.
• If the temperature is too low, the iron soleplate does
not become hot enough to evaporate the water.
Thereby water will be able to discharge from the iron
soleplate when you keep the steam button
• Set the temperature control at least to the "
• Adjust the amount of steam to the temperature of the
iron with the steam flow controller.
• The soleplate might cool down after continuously long
steam ironing. Thus it is possible that water escapes
out of the soleplate. This is not a malfunction of the
appliance. Reduce the steam level with the steam flow
controller. Or you can wait until the iron soleplate has
heated up again before pressing the steam button
again.
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the appliance has cooled down completely!
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
42
DBS6033CB_IM

Vertical Steam Function

The vertical steam function allows a constant burst of steam
in a vertical direction. This function can be used to remove
creases from hanging clothes or from curtains.
WARNING:
Do not direct the steam at any persons. Danger of burns!
Hang the washing on a hanger. Guide the iron closely over
the material as specified by the material.

How Can I Replenish the Water During Operation?

Refill with water before the tank is completely empty. A loud
noise of the pump during operation indicates that the water
pressed.
level is too low.
" symbol.
1. Place the iron on the rest.
2. Set the temperature control to " MIN ".
3. Turn the appliance off by setting the on / off switch to " O ".
4. Remove the mains plug from the socket.
5. Pull the water tank out of the base.
6. Fill the water tank only with distilled water. Fill the water
tank to the maximal marking only. Do not overfill!
7. Put the water tank back into position.
8. Put the power plug into the socket.
9. Set the on / off switch to " I " to turn the appliance on.
10. You can now continue ironing.

When You Have Finished

1. Turn the appliance off by setting the on / off switch to " O ".
2. Allow the appliance to cool down before you put it
away.

Cleaning

• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be poured out if it has been in the tank for a
prolonged period.
09.03.20