Advertisement
Instruction Manual >
REAR MOUNTING
BUSHING
Repeat Steps 1-3 on the left side.
4.
Install the supplied side plates on to the sissy bar with the four M8 X 16 mm button head bolts. Make
5.
sure the u-shaped grommets are facing the same direction as the sissy bar pad and the part numbers
are facing inward. See FIGURE 3. Snug the bolts but DO NOT TIGHTEN at this time.
SISSY BAR
PAD
M8 X 16 mm
BUTTONHEAD
BOLTS
PART NUMBER
FACING INWARD
Install the sissy bar onto the bike by first inserting the front portions of the side brackets on to the front
6.
mounting bushings on the frame rails. Make sure the sissy bar is seated all the way onto the mounting
bushings. See FIGURE 4.
Then slowly rotate the sissy bar downward so the rear portions of the brackets slip over the rear
7.
mounting bushings. See FIGURE 4.
DOCUMENT NO. 0018
REV. A
06/18
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180 Fax. 714.692.5016
®
FIGURE 2
FIGURE 3
CONTINUED ON PAGE 3
602-2046 / 602-2046B
NOTE: ACTUAL
PART MAY VARY
FROM IMAGE
www.cobrausa.com
Page 2 of 3
FRONT
MOUNTING
BUSHING
M8 X 16 mm
BUTTONHEAD
BOLTS
PART NUMBER
FACING INWARD
SHOWN
®
Advertisement
