Table of Contents
Advertisement
Precautions and Notes
You can get instructions and information that you must read after installation.
Before Using the Recording and Timeshift Functions
Read these instructions before using Recording and Timeshift.
Before using the recording and schedule recording functions
Recording may not be supported depending on the model or geographical area.
• To schedule a recording, set
–
Menu
Try Now
• You can set up a maximum total of 30
• Recordings are DRM-protected and therefore cannot be played back on a computer or on a different TV. In
addition, these files cannot be played back on your TV if its video circuit has been replaced.
• For a USB device for recording, it is recommended to use the USB hard disk that supports USB 2.0 or later and
5,400 rpm or higher. However, RAID-type USB hard drives are not supported.
• USB memory is not supported.
• The total recording capacity may differ with the amount of available hard drive space and the recording quality
level.
•
Schedule Recording
available storage space falls below 50 MB while recording is in progress.
• If the available storage space falls below 500 MB while both the Schedule Recording and Timeshift functions are
in progress, only the recording will stop.
• The maximum recording time is 720 minutes.
• Videos are played according to the TV settings.
• If the input signal is changed while recording is in progress, the screen will go blank until the change is made. In
this case, recording will resume, but
Clock Mode
to Auto. Set the Clock.
Settings
All Settings
Schedule Viewing
requires at least 100 MB of free space on the USB storage device. Recording will stop if the
will not be available.
General & Privacy
System Manager
and
Schedule Recording
- 173 -
Time
Clock
entries.
Advertisement
Table of Contents
