SETTINGFURTHERCHANNELS
Automaticserviceupdate
If this function is activated, possible changes of
network operators are updated automatically.
The unit must be located in stand-by mode.
This updating affects all types of reception - ter-
restrial, cable and satellite.
1
Open the menu with »MENU«.
2
Select menu item »Settings« with »
<
>
»
« or »
« and press »OK« to confirm.
3
Select the menu item »Source« with »
<
»
« and press »
– » Source« menu is active.
4
Select the line »Advanced« with »
»
« and press »OK« to confirm.
Λ
5
Select the line »Automatic Service Update«
with »
« or »
V
Λ
<
update with »
« or »
6
Press »EXIT« to end the setting.
100
ENGLISH
«, »
V
>
« to confirm.
V
« or
V
« and select the automatic
>
« (»On«).
-----------------------------------------------------
Tuninganaloguetelevision
channels
This setting is only necessary if you cannot
receive any digital channels and you have not
carried out an analogue search during initial
setup.
The television channel can be set directly or
using the search.
«,
Λ
Settingallanaloguetelevisionchannels
The analogue television stations are listed in the
« or
channel list after the digital television stations.
Note:
Plug the rooftop antenna cable (for ana-
7
logue television stations) into the ANTIN
socket on the television.
1
Open the menu with »MENU«.
2
Select menu item »Settings« with »
<
»
« or »
3
Select the menu item »Source« with »
<
»
« and press »
– » Source« menu is active.
4
Select the line »Automatic Channel Search«
with »
V
confirm.
5
Select the option »Air (DVB-T/T2)« or
»Cable (DVB-C)« with »
confirm the source you are receiving analog
broadcast from by pressing »OK«.
6
Select the option »Digital« with »
»
« and press »OK« to remove the small
Λ
tick.
7
Press »
>
« and press »OK« to confirm.
« to confirm.
V
« or »
« and press »OK« to
Λ
« or »
V
« (red) to start searching.
«, »
«,
V
Λ
>
« or
« and
Λ
« or
V