Media Browser - Saba SCB1910VX Operating Instructions Manual

After APS is finalized, the programme table will appear
on the screen. In the programme table you will see
the programme numbers and names assigned to the
programmes.
Channel Search
In manual channel scan, the number of the multiplex is
entered manually and only that multiplex is searched
for the channels. For each valid channel number, signal
level and signal quality are shown on the screen.
In both manual and auto search any existing channel
in the database is not re-stored to avoid redundant
duplicates of that channel.
Clear Service List (*)
(*) This setting is visible only when the Country option
is set to Denmark, Sweden, Norway or Finland.
Use this setting to clear channels stored. Press " " or " "
button to select Clear Service List and then press OK. The
following OSD message will be displayed on the screen:
Highlight NO and press OK to cancel. Select Yes by
pressing " " or " " button and press OK to delete all
of the channels.
First Time Installation
The user can use this item to load default settings,
which were loaded to the receiver at the factory.
To install factory settings, highlight "First Time
Installation" menu item and press "OK" button, then
you will be asked whether or not to delete the settings.
Selecting "Yes" by pressing "OK" button while "Yes" is
highlighted will delete the existing channel table.
Then you will be asked to confirm for deleting all
channels and settings:
By selecting Yes and pressing the "OK" button, the
existing channel table will be deleted. After factory
settings are loaded, "First Time Installation" menu
will be displayed.
The menu which is displayed for language selection
appears on the screen at first. By using " " or " "
buttons, select the desired language option, and press
OK button to activate.
Afterwards, "First time installation" OSD will appear
on the screen. By pressing " " or " " buttons, select
the Country you want to set and press "OK" button
(* only for EU countries).
Press the "OK" button to start installation. After search
is completed for digital channels, a message asking
whether to search for analogue channels appears
on the screen.This process is same as described in
Automatic Search section..

Media Browser

• To display Media Browser window, press either
"MENU" button on the remote control and then
select Media Browser by pressing " " or " " button.
Press "OK" button to continue. Media Browser menu
contents (depending on the contents of your USB
drive) will be displayed.
• Also, when you plug a USB device, the following
screen will be displayed:
Select YES by pressing " " or " " button and press
OK button. Media browser will be displayed.
• You can play music, picture and video files from a
USB memory stick.
Note: If you plug USB stick while in analogue mode, the TV
will automatically switch to digital TV mode.
Note: Some USB compliant devices may not be supported.
Note: If the USB stick is not recognized after power off/on
or First Time Installation, first, plug the USB device out and
power off/on the TV set. Plug the USB device in again.
English - 61 -