Table of Contents
Advertisement
HANDLING THE UNEXPECTED
and then remain continuously illuminated. This sequence will continue upon
subsequent vehicle start-ups as long as the malfunction exists.
When the malfunction indicator is illuminated, the system may not be able to
detect or signal low tire pressure as intended.
TPMS malfunctions may occur for a variety of reasons, including the
installation of replacement or alternate tires or wheels on the vehicle that
prevent the TPMS from functioning properly.
Always check the TPMS malfunction telltale after replacing one or more
tires or wheels on your vehicle to ensure that the replacement or alternate
tires and wheels allow the TPMS to continue to function properly.
Fixing a Tire
If a tire goes flat while driving, grasp the steering wheel firmly and brake
gradually to reduce speed. Then stop in a safe place.
Getting Ready to Temporarily Repair the Flat Tire
n
If the tire has a large cut or is otherwise severely damaged, you will need to
have the vehicle towed. If the tire only has a small puncture, from a nail for
instance (do not remove the nail), you can use the temporary tire repair kit
so that you can drive to the nearest service station for a more permanent
repair.
1. Park the vehicle on a firm, level and non-slippery surface, and apply the
parking brake.
2. Change the gear position to Park (P).
3. Turn the hazard warning lights and set the power mode to VEHICLE OFF
(LOCK).
4. Open the trunk floor lid.
126 |
5. Take the kit out of the case.
6. Place the kit face up, on flat ground
near the flat tire, and away from
traffic. Do not place the kit on its
side.
Injecting Sealant and Air
1. Remove the valve cap from the tire valve stem.
2. Remove the sealant/air hose from the packaging.
3. Attach the sealant/air hose onto the tire valve stem. Screw it until it is
tight.
4. Plug in the compressor to the accessory power socket.
5. Start the engine. Keep the engine running while injecting sealant and air.
6. Turn the selector switch to REPAIR (for U.S. models) or SEALANT/AIR or
PRODUIT ANTIFUITE/AIR (for Canadian models).
7. Press the inflator switch to turn on the compressor
8. After the air pressure reaches to specified pressure, turn off the kit.
9. Unplug the power plug from the accessory power socket.
10. Unscrew the sealant/air hose from the tire valve stem. Reinstall the
valve cap.
11. Press the pressure relief button until the gauge returns to (0 kPa).
12. Apply the repair notification label to the flat surface of the wheel.
Running the engine with the vehicle in an enclosed or even partly enclosed
area can cause a rapid build-up of toxic carbon monoxide. Breathing this
colorless, odorless gas can cause unconsciousness and even death. Only
run the engine to power the air compressor with the vehicle outdoors.
HANDLING THE UNEXPECTED
| 127
Advertisement
Table of Contents
