Advertisement
• The pulsate rotates for
40 seconds to detect the
laundry load,
• Then the Waster Level and
the amount of Detergent
to be used will be shown
and water will be supplied.
Close the lid
• Water will be supplied
• When the wash
for 2 minutes after
the start of the wash
to supplement the
water the laundry
has absorbed.
Finish
• If water is already in the tub, or putting
wet laundry into the tub before starting
will increase the Water Level.
• With lightweight bulky loads, Water
Level can be set low.
program ends, the
• Changes to Water Temperature (Hot/
buzzer will ring for
Cold) and wash level are possible during
10 seconds before
the Power goes off
operation. (refer to page 14)
automatically.
• When setting the Water Level manually,
do not set to Medium to prevent damage
to laundry.
• Washing with Hot water may damage
the laundry (Water is set to cold
automatically). Ensure that the load
is under 2 kg.
• In order to avoid damage to laundry,
the spin cycle may appear slow. This
also avoids wrinkles and clothing may
still contain some water. This is normal
• When static pressure of water is more
than 2 kgf./cm².
Caution & Note
17
Advertisement
