Table of Contents
Advertisement
2nd
3rd
Auto Source Switch
Key Repeat Time
Power LED On
Description
When there is no signal, the display automatically switches to the newly connected device.
― This function may not be supported depending on the model or geographical area.
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
No Repeat
is selected, a command responds only once when a button is pressed.
27
Advertisement
Table of Contents
