1. Precautions 1. Precautions 1-1. Safety Precautions Follow these safety, servicing and ESD precautions to prevent damage and to protect against potential hazards such as electrical shock. 1-1-1. Warnings For continued safety, do not attempt to modify the circuit board. Disconnect the AC power and DC power jack before servicing.
1. Precautions 1-2. Servicing Precautions WARNING: An electrolytic capacitor installed with the wrong polarity might explode. Caution: Before servicing units covered by this service manual, read and follow the Safety Precautions section of this manual. Note: If unforeseen circumstances create conflict between the following servicing precautions and any of the safety precautions, always follow the safety precautions.
1. Precautions 1-4. Installation Precautions For safety reasons, more than two people are required for carrying the product. Keep the power cord away from any heat emitting devices, as a melted covering may cause fire or electric shock. Do not place the product in areas with poor ventilation such as a bookshelf or closet. The increased internal temperature may cause fire.
2. Product specifications 2-2. Spec Comparison to the Old Models [SA450] [CREAM] Model S22A450BW SN1933 Design Resolution 1680 X 1050 1600 X 900 Analog / DVI digital with HDCP Input Analog / DVI digital with HDCP ( 2033SN : Analog only )
Page 14
Product Description Code. No Remark Manual Flyer- Adapter Guide BN68-03162J Warranty Card BN68-03548A (Not available in all locations) User’s Guide BN46-00080A Stereo Cable BN39-00061C Samsung Electronics Service center D-Sub(15 Pin) Cable BN39-00244H USB Cable BN39-00397C Power Cord 3903-000382 Adapter BN44-00394F...
5. Wiring Diagram 5-2. Board Connection * For analog model, main PBA just has D-SUB Jack, no DVI Jack. RGB Connector DVI Connector (Connect to PC) (Connect to PC)
5. Wiring Diagram 5-3. Connector Functions Connector Functions CN101 CN600 Supplies 5V from the power board to the main board and transmits the PWM output from the power board to the inverter. *When a problem occurs: The No Power and Blank Screen errors may occur. CN1 ~ CN4 In Transmits the lamp current (110mA ~ 112mA) generated in the inverter to the lamp of the panel.