Table of Contents
Advertisement
Caution
• Do not install the printer in the following locations. If the printer is not installed in the proper
location, a fire or electric shock could occur.
– A damp or dusty location.
– A location exposed to oily smoke or steam; e.g., near a countertop or humidifier.
– A location exposed to rain or snow.
– A location exposed to salty wind.
– A location subject to high temperatures.
– A location near open flames.
• Do not place the printer in an unstable location; e.g., on a wobbling or inclined table, or a location
subject to frequent vibrations. The printer could fall down or fall over, resulting in personal injury.
• Never place the printer where it will be exposed to rapid changes in temperature, such as indirect
sunlight, near an air conditioner, or in a car on a hot day. This could cause a fire or damage to the
printer.
Important
• Use the printer in the following operating environment:
Operating environment: 15 to 30 degrees Celsius (59 to 86 degrees Fahrenheit)
• If the printer is carried into a warm room on a cold day, this could cause condensation inside the printer.
If this happens, allow the printer to sit for at least 1 hour at room temperature to adapt to the ambient
temperature and humidity.
• Do not install under strong light. This could cause a malfunction.
• To ensure normal operation of the printer and avoid possible damage, do not install the printer near large
office equipment or any other type of electrical device that emits a strong magnetic field.
• Never block the ventilation ports on the printer. A blocked ventilation port could cause heat to build up
inside the printer and cause a fire.
Power Supply
■
Warning
• Do not use any power cord other than those supplied with the printer. This could cause a fire or
electric shock.
RH 10% to 80% (with no condensation)
Important Safety Instructions
4
Advertisement
Table of Contents
