Table of Contents
Advertisement
4.4 Maintenance and cleaning
A
Please read the "Safety Instructions" section first!
Service life of product extends and frequently experienced problems will be reduced if it is cleaned at regular
intervals.
4.4.1 Cleaning the detergent drawer
1
Press the marked part of the syphon within the softener compartment and then pull the drawer towards
yourself to take it out.
2
Lift and remove the syphon from behind as shown.
3
Rinse drawer and syphon in the sink with plenty of warm water. Use gloves or suitable brush to prevent
contact of residues in the drawer with your skin.
3
Firmly fit the syphon and the drawer back after cleaning.
4.4.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please see the Operating the product section
C
Repeat Drum Cleaning process in every 2 months.
WARNING:
4.4.3 Cleaning the body and control panel
Wipe the body of the product with soapy water or non-corrosive mild gel detergents as necessary, and dry
with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
4.4.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the product and also at the end of each
water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the product. Filters should be cleaned if they are dirty.
33 / EN
Clean the detergent drawer at regular intervals (once every 4 to 5 wash)
as mentioned below to prevent accumulation of powder detergent.
Clean the syphon if excess amounts of water and fabric softener mixture
remains in the softener compartment.
Use an anti-limescale suitable for the washing machines.
After every washing make sure that no foreign substance is left in the
product.
If the holes on the bellow shown in the figure is blocked, open the holes
using a toothpick.
Foreign metal substances will cause rust stains in the drum. Clean the
stains on the drum surface by using cleaning agents for stainless steel.
Never use steel wool or wire wool. These will damage the painted,
chrome coated and plastic surfaces.
We recommend you to wipe the bellows with a dry and clean cloth at
the end of the program. This will remove residues on the bellows in your
machine and prevent formation of malodours.
Washing Machine / User Manual
Advertisement
Table of Contents
