Advertisement
Table of Contents
- 1 Table of Contents
- 2 Introduction
- 3 The Top Panel
- 4 The Bottom Panel
- 5 The DSP Section
- 6 Storing Your Own Presets
- 7 Restoring the Factory Presets
- 8 More about the Save/Tap Button
- 9 Using the Footswitch for more Presets
- 10 DSP Factory Presets
- 11 DSP Factory Presets
- 12 Suggested Settings
- 13 DSP "Fill in the Blanks" (for User Presets)
- 14 System Block Diagram
- 15 Technical Specifications
- Download this manual
Advertisement
Table of Contents
Related Manuals for Crate E60065
Summary of Contents for Crate E60065
- Page 1 Guitar Amplifier with Digital Effects User’s Guide...
-
Page 2: Table Of Contents
Product Type: Audio Amplifier Products meet the regulations for compliance marking under: ETL standards UL6500, UL60065, or UL813 CSA standards E60065 or C22.2 No.1-M90 CE safety standard EN60065 CE EMC standards EN55103 or EN55013 and EN61000 C-tick designation Level 2, ABN #56748810738, ARBN# N222 KETI standard K60065 (limited model approval) Compliance Support Contact: SLM Electronics, Attn: R&D Compliance Engineer... -
Page 3: Introduction
Congratulations You are now the proud owner of the Crate RFX65 three-channel guitar amplifier with Advanced Digital Signal Processing. This rugged amplifier combines outstanding features with serious clean and distorted sounds. Dual DSP controls provide 15 “Multi” effects and 15 Delay effects which can be combined for a wide variety of sounds. The Save/Tap button allows you to manually set the tempo of many of the effects and to save new DSP presets in the amplifier’s non-volatile memory. -
Page 4: The Top Panel
The Top Panel: SOLO INPUT GAIN SHAPE 1: INPUT: Use this jack to connect your guitar to the amplifier by means of a shielded instrument cable. SOLO/RHYTHM CHANNELS: High gain channels giving you sounds with serious overdrive. 2: SOLO LED: This LED illuminates when the Solo channel is selected. 3: GAIN: Use this control to adjust the amount of distortion produced by the Solo channel. - Page 5 21 22 DELAY DELAY REVERB REVERB TAPE TAPE ECHO ECHO SAVE / TAP SAVE / TAP SINGLE SINGLE RHYTHM / SOLO CLEAN LEVEL VOLUME 13 14 17: MID: Use this control to adjust the midrange frequency level of the Clean channel. 18: HIGH: Use this control to adjust the high frequency level of the Clean channel.
-
Page 6: The Bottom Panel
The Bottom Panel: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. -
Page 7: The Dsp Section
The DSP Section: The RFX65 features DSP controls for Multi, Delay and Reverb. Complete information about the Multi and Delay effects is given below. The Multi control selects the “pitch modified” and wah effects. Many of these effects have their speed controlled by the Save/Tap button. The Delay control selects the delay or echo effects. -
Page 8: Storing Your Own Presets
Storing Your Own Presets: Each channel of the RFX65 has two factory assigned DSP presets, as shown on pages 10 and 11. No matter what the settings of the DSP controls, the preset is recalled when a channel is selected. You may change the DSP settings by rotating the DSP con- trols - these changes will remain active until a different channel is selected, but will not be there for later use unless they are saved. -
Page 9: Using The Footswitch For More Presets
Using the Footswitch for More Presets: The Crate three-button footswitch supplied with the RFX65 allows access to an addi- tional DSP preset for each channel of the amplifier. When the footswitch is connected to the amplifier as shown below, the “original” DSP presets are active for each channel when the #3 footswitch LED is illuminated. -
Page 10: Dsp Factory Presets
DSP Factory Presets: The RFX65 Factory Presets for the DSP section are as follows: Factory Preset 1: Clean w/Chorus, Delay,Reverb CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" Factory Preset 2: Rhythm w/Slapback Delay CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" Factory Preset 3: Solo w/Flange,Delay,Reverb CHANNEL: SOLO... -
Page 11: Dsp Factory Presets
DSP Factory Presets: The RFX65 Factory Presets for the DSP section are as follows: Factory Preset 4: Clean w/Reverb CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" Factory Preset 5: Rhythm w/Reverb CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" Factory Preset 6: Solo w/Reverb CHANNEL: SOLO RHYTHM... -
Page 12: Suggested Settings
Suggested Settings: "Oceanic" Clean with SOLO Vibrato, Delay, & Reverb GAIN SHAPE LEVEL "Super Funk" Clean with Wah, Delay, SOLO & Reverb GAIN SHAPE LEVEL "Arena" Rhythm with SOLO Reverb & Delay GAIN SHAPE LEVEL TAP Tempo MEDIUM MULTI MULTI DELAY DELAY PHASER... - Page 13 Suggested Settings: "Haze Faze" Rhythm with Phase SOLO & Reverb GAIN SHAPE LEVEL "Solo Wah" Solo with SOLO Wah, Delay & Reverb GAIN SHAPE LEVEL "Octanator" Solo with SOLO Octave & Reverb GAIN SHAPE LEVEL TAP Tempo MEDIUM MULTI MULTI DELAY DELAY PHASER...
-
Page 14: Dsp "Fill In The Blanks" (For User Presets)
DSP “Fill in the Blanks” (User Settings): Copy this page to fill in your own DSP Presets! User Preset: _________________________________ CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" User Preset: _________________________________ CHANNEL: SOLO RHYTHM CLEAN BANK: "A" "B" User Preset: _________________________________ CHANNEL: SOLO RHYTHM... -
Page 15: System Block Diagram
System Block Diagram: TUNER A BC D EF G BUFFER INPUT SOLO RHYTHM RHYTHM SOLO SOLO RHYTHM GAIN GAIN MULTI DELAY CLEAN VOLUME MID HIGH SOLO SOLO SWITCHING LEVEL CIRCUIT RHYTHM RHYTHM SHAPE HIGH LEVEL REVERB POWER INPUT DAMPING CIRCUIT Guitar Amplifier SOLO/ RHYTHM/... -
Page 16: Technical Specifications
RFX65 TECHNICAL SPECIFICATIONS: Output Power Rating Speaker Size and Rating Input Impedance Total System Gain Solo Ch Rhythm Ch Clean Ch CD Input Maximum Input Signal Accepted Solo Channel Shape Control Rhythm Channel Low Control Mid Control High Control Clean Channel Low Control Mid Control High Control...
Need help?
Do you have a question about the E60065 and is the answer not in the manual?
Questions and answers