Braun 7 Series Manual page 29

Manual cleaning
Rinsing the shaver head under running water
is an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless)
the shaving head under hot running water until
all residues have been removed. You may use
liquid soap without abrasive substances. Rinse
off all foam and let the shaver run for a few
more seconds.
• Next, switch off the shaver, press the release
9
button to remove the Foil & Cutter cassette
8
and let it dry.
• If you regularly clean the shaver under water,
apply a drop of light machine oil onto the
shaver foil and long hair trimmer. This is critical
for proper functioning of the shaver as washing
under water can lead to removal of lubricants
from the shaver's cutting parts leading to
higher friction in the shaver. This may result
in the battery running out faster than normal.
Even if this happens – indicated by low charge
indicator lighting up earlier, your Braun shaver
will run for at least 5 more minutes enabling
you to complete your current shave.
Alternatively, you may clean the shaver with a
brush:
• Switch off the shaver. Remove the Foil & Cutter
8
cassette and tap it out on a fl at surface.
Using the brush, clean the inner area of the
pivoting head. However, do not clean the
cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the
shaver and the Clean&Renew station with a
damp cloth, especially inside the cleaning
chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button
housing, wait for a few seconds before removing
the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure
to close the openings using the lid of the new
cartridge, since the used cartridge will contain
contaminated cleaning solution.
w
and rinse
2
to open the
Series
Ser ies
r e l e as e
Series 7
r e l e as e
click!
Series 7
r e l e as e
Series 7
r e l e as e
Series 7
r e l e as e
r e l e as e
new
old
29