Troubleshooting Methods; Troubleshooting According To Display Error Message - LG XD3 25U Series Service Manual

7. TROBLESHOOTING METHODS
7-1. tRoubleshooting accoRding to displayed eRRoR message
eRRoR message
INLET ERROR
displayed
Condition
doesn't reach the normal
water level
level(automatically
drainpump operated)
DRAIN ERROR
displayed
Condition
doesn't drain the water
LEAKAGE ERROR
displayed
Condition
internal leakage
BUBBLE ERROR
displayed
possible cause
foR eRRoR occuRRence
1) the water supply tap is closed.
2) wiring connection is ok?
3) the inlet hose is kinked.
4) the water pressure is very low (below
0.05 mpa) or high (above 0.6 mpa).
5) the filter of inlet valve is clogged by
dirty water.
6) inlet valve is ok?
7) wiring connection is ok?
8) the impeller of air breaker is stuck.
9) the hall sensor is ok?
10) the controller is damaged.
1) the filter assembly blocked.
2) the drain hose kinked or blocked.
3) the inner hole of drain case is blocked.
4) the air gap is clogged.
5) the knock out plug of garbage
disposal not removed.
6) the washing motor locked or
defective.
7) wiring connection is ok?
8) the impeller of drain motor is stuck.
9) the controller is damaged.
1) the door gasket came loose or fell
off.
2) the float assembly is stuck.
3) the controller is damaged.
4) the seal assembly is not connected
properly to the sump.
5) the unit is not leveled.
6) using wrong detergent.
1) oversudsing caused by improper
detergent, such as liquid dish soap.
2) failure to level dishwasher
- 31 -
For Authorized Service Technicians
Remedy
1) open the water supply tap.
2) check and reconnect the wire.
3) Repair the inlet hose.
4) call plumber for service.
5) clean the filter of inlet valve.
6) check the electric resistance of inlet
valve. (3438 ~ 4202Ω)
7) Replace the water Jacket.
8) check the electric resistance of hall
sensor.
9) Replace the controller.
1) clean the filter assembly.
2) Remove the cause of kink or block.
3) Repair or Replace the drain motor.
4) clean the air gap
5) Remove knock out plug.
6) Replace the pump casing assembly.
7) check and reconnect the wire.
8) clean the drain motor
9) Replace the controller.
1) Replace the door liner assembly.
2) Replace the floater assembly.
3) Replace the controller.
4) Reassemble the seal on the sump.
5) make a level. should install properly.
6) use dishwasher detergent.
※ in case of ae, should remove
underneath of floater switch(safety
switch)
1-1) do not use hand dishwashing
liquids. only use detergents which
are designed for use in automatic
dishwashers.
1-2) to remove detergent residue in the
tub, pour approximately 100~200 m
ℓ of milk into a shallow bowl, place it
to the upper rack and then run the
appliance on the auto cycle.
2) make sure that the appliance is
properly leveled.