Omega SUZUKA 715-1530 User Manual page 20

EN
notice
Woods and branches diameter should not exceed 100-120 mm (depending on the model).
warning
Do not place your hands into the chute when loading. This is a very UNSAFE method and could result in injury to
your hands. Do not reach or step across the rail while the Wood Chipper is running. This is a very UNSAFE method which could
cause personal injury, even death.
When blocked
If the Roller stops while chipping woods or branches, the engine should be stopped, and take out the woods which stuck the roller,
and then restart the engine, and chip again.
4. maintenance
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual and
the engine manufacturer's user manual for maintenance procedures.
warning
Before performing any maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts to
cool. Disconnect the spark plug wire, keeping it away from the spark plug. Disconnect the battery terminals (Electric start only).
Regular maintenance checklist
Procedure
Check engine oil level
Check general equipment
condition
Check belts
Check tire pressure
Clean engine exterior and
cooling
Change engine oil
Replace air filter
Replace spark plug
Lubrication
notice
All bearings of your wood chipper are sealed units and should have sufficient lubricant to last the life of your machine
with normal use.
Greasing the rack and pinion
notice
All the rack and pinion should be greased before every use.
Before each use Every 3 hours
X
X
X
First time 5 hours
Every 25 hours
8
Every 100 hours
X
X
X
X
X