Pioneer CT-W300 Operating Instructions Manual page 14

Symptom
Probable Cause
POWER
Cannot turn power on.
=
® The power plug is removed.
*® The component (stereo amplifier, audio
connected is off.
timer, etc.) to which the power cord is |
1 @ Insert the power plug correctly.
® Turn the stereo amplifier or audio timer on.
CASSETTE DOOR
The door does not open.
moving}.
The door does not close.
The cassette is not properly loaded.
PLAYBACK
Immediately stops.
—
The tape is completely wound.
The level meter does not
work,
© The tape is not recorded.
* The tape head is dirty.
I No sound
—-
| ® The amplifier input selector is not correctly
set.
© The amplifier volume level setting is too
low.
® Connection problems {wrong connection,
cord removed, poor contact, broken wire).
RECORDING
© Replace the tape with a recorded one.
® Clean the head (see page 13).
* Set the amplifier input selector correctly.
* Turn the amplifier volume control up.
* Connect securely.
The recording button can
not be depressed.
The cassette erasure prevention tabs are
broken.
Replace the cassette with one whose tabs
are intact.
The level meter does not
work,
® The REC LEVEL control is set too low.
¢ The amplifier is not delivering a recording
signal {from the tuner, CD player, etc.).
e® Wrong connection, connection cord
removed, poor contact, broken wire.
e Turn the REC LEVEL control up.
* Set the amplifier recording output selector
correctly.
¢ Check connections.
Immediately stops.
}
| The tape is completely wound up.
Rewind the tape.
Cannot record
The head is dirty.
Clean the head (see page 13).
14
<RRB1025>