Advertisement
2.2 General information
Remove the polystyrene basket retainers.
Position the appliance in the desired place of
installation.
This appliance may be placed up against walls or
other furniture units.
If the appliance is installed near a heat source, fit a
special insulating panel to prevent overheating and
malfunction of the appliance.
To ensure stability, install integrated or built-under
dishwashers only under continuous worktops, and
screw them to the adjacent units.
To facilitate the installation procedure, the intake
and drain hoses can be positioned in any direction;
make sure that the hoses are not kinked, crushed or
pulled too tightly.
Make sure to tighten the locking ring nut once the
hoses have been placed in the direction required.
A hole at least 8 cm in diameter is required to allow
the power supply cable and hoses to pass.
At the end of the installation, perform a short test of
the appliance: open the water tap and check that
there are no leaks.
To install the dishwasher against the back wall, the
hoses should be passed through the lower area
where there is a dedicated space for them.
The following spare parts will be available for 7
years after the model is no longer produced: wash
Installation
10
Advertisement
Troubleshooting
