Advertisement
Istruzioni per l'utente
INTERRUPTION A PROGRAM
To interrupt a program in progress:
press the START/PAUSE button (7); the light of the program in
progress remains on (confirmation beep);
you may now restart the program by pressing button (7) again
until it restarts, or change or annul the program (see "C
A PROGRAM
CHANGING A PROGRAM
To change the running program it is necessary:
to interrupt the running program (see "I
select the new program;
start the program (see "S
ANNULLING A PROGRAM
To annul the program, keep the START/PAUSE button (7) pressed until
the program is interrupted (light on and confirmation beep).
Press button (7) again and keep it pressed until the
lights 4 and 5 (marked "end") come on.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
S
TARTING THE PROGRAM
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will
start about 60 seconds later.
", or "A
NNULLING A PROGRAM
TARTING THE PROGRAM
". The program will resume from the
").
NTERRUPTION A PROGRAM
").
HANGING
");
17
Advertisement
