Advertisement
MECHANICAL ADJUSTMENTS
CONTROL AMPLIFIER
P.C.BOARD MOUNTING
Mount the P.C.Board by the following procedures.
1. Mount
the Control
Amplifier
P.C.Board
by temporarily
tightening the three screws, so that the Stop Lever of the
Completed Select Button is located below the Release Lever
of the Function Switch as illustrated.
Control Amplifier P.C.Board
Release Lever
Stop Lever
Serew
fr
1
j
Cotrol Amplifier P.C.Board
move the P.C.B.
NOTE:
The Control Amplifier P.C.Board can easily be slid.
2. Move the P.C.Board to bring each Select Button Lever into
contact
with
each
switch.
Then,
adjust
the
mounting
position
of the P.C.Board
correctly confirming
that each
button except PAUSE
button is securely locked by moving
the P.C.Board.
Function Switch
Select Button Lever
3. After tightening the mounting screws, try to push the Select
Buttons again and confirm that they are securely locked.
Py [ae
STOP SWITCH POSITION ADJUSTMENT
1. Push one of the Select Buttons and lock it. Then, gradually
push the STOP button. The Select Button should be released
after the Stop Switch is changed over.
2.
If necessary,
loosen
the screw
fastening
the Switch
and
adjust the position by moving the Switch as illustrated.
Stop Switch
3. After the adjustment, tighten the screw and secure it with
paint or glue.
NOTE:
Turn
off the Power Switch whenever
this adjustment
is
performed.
R/P SOLENOID POSITION ADJUSTMENT
1. Remove
the Cover and Complete Front Panel by following
instructions given earlier.
Prepare for a spacer of 0.3mm as illustrated.
2.
Loosen the two screws fastening the Solenoid and insert the
spacer in the Solenoid as illustrated. Then, set the unit in the
playback mode by pushing the PLAY button.
R/P Solenoid
MeseorscEtiosececy
move the
Solenoid
Adjusting Hole
Slide Base
Advertisement
