DISASSEMBLY INSTRUCTIONS (continued)
3. Remove
six screws
(31 — 36) fastening the Switches, and
remove
Nut
(M) and washer
holding
the
INPUT
Level
Controls.
4,
Remove
four screws
(42 — 45) fastening both sides of the
Chassis.
5. Unsolder the five lead wires (two black, blue, red, and gray)
from
the Meters
and
pull out the four connectors
(CN4,
CN5, CN7, and CN9}
from
the Amplifier Base P.C.Board,
and the two connectors (CN22 and CN23) from the Power
Supply P.C.Board.
6. Pull the Chassis Assembly off the unit.
7. Reassemble in reverse order.
NOTE:
Refer
to
the
Wiring
Diagram
when
the connectors
are
attached to the Amplifier Base P.C.Board and the lead wires
are soldered to the Meters.