Table of Contents
Advertisement
Operating Instructions
6.5 Start the Machine
WARNING!
Before you start the machine, read and
understand all of the safety information in this
manual and the engine manufacturer's manual.
IMPORTANT! Use short starting cycles (maximum five
seconds) and wait one minute between cycles. If the engine
does not start after repeated attempts, contact your local
dealer or go to VanguardPower.com.
1. Before you start the machine, see the information under
Controls on page 20.
2. Complete the Pre-Start Checklist on page 24.
3. Make sure that the machine is level and in a stable position.
4. Move the choke control to the Closed position.
5. Move the throttle control to the Fast position.
6. Firmly grip the starter-cord handle.
7. Pull the starter cord out slowly until you feel resistance,
then pull rapidly.
8. As the engine warms up, move the choke control to the
Open position.
6.6 Stop the Machine
1. Stop putting material into the machine.
2. Wait for a minimum of 30 seconds to let all the material
blow out of the machine.
Material in the rotor housing can cause the engine to stall
the next time you start the machine.
3. On the engine, move the throttle lever to the SLOW position.
4. Wait a minimum of one minute for the engine to decrease
the rotor speed.
5. Move the fuel shut-off valve to the Fuel shutoff closed
position to stop the engine and close the fuel shut-off valve.
6.7 Emergency Stop
In an emergency:
1. Stop putting material into the machine.
2. Move the fuel shut-off valve to the Fuel shutoff closed
position to stop the engine and close the fuel shut-off valve.
3. Do not let anyone start the machine until the emergency is
resolved.
6.8 Set Up the Machine
Always use the machine outdoors and park
the machine in a position where the prevailing
winds blow the engine exhaust away from the
operator. Exhaust from the engine contains
carbon monoxide (CO) that can accumulate to a
dangerous level, even in an area with good air
fl ow.
For more information, see Figure 18 on page 29.
1. Select a work site and set up a safe work area.
For more information, see Work Site on page 11.
2. Do one of the following:
• Disconnect the machine from the tow vehicle.
For instructions, see Disconnect from a Tow Vehicle on
page 32.
• If more stability is necessary, leave the machine
attached to the tow vehicle. Set the tow vehicle's
parking brake, stop the engine, and then remove the key
from the ignition.
3. Lower the jack stand to support the machine in a level
position. The machine should be as level with the ground
as possible.
For instructions, see Lower the Jack Stand on page 32.
4. Turn the discharge chute to direct the wood chips away
from the operator and in the direction of the wind.
For instructions, see Discharge Chute on page 21.
5. Move the hood deflector to direct the wood chips further
away from or closer to the machine.
For instructions, see Hood Deflector on page 22.
6. Make sure that the rotor housing is closed and the fastener
is tight.
7. Make sure that all guards and shields are installed, and the
covers are closed.
28
Chipper / Shredder
WARNING!
BXMT3209
W006
Advertisement
Table of Contents
