Toro Z Master Professional 7500-D Series Installation Instructions page 3

3. Turn the seat-support plate over, so that the
bottom side is facing upward.
4. Ensure that the heat shield is oriented correctly
(Figure 3), then place the heat shield on top of
the seat-support plate and align it with the drilled
hole.
5. Mark the three remaining hole locations on the
heat shield onto the seat-support plate.
6. Remove the heat shield.
7. Drill the three holes (7 mm or 9/32 inch) into the
seat-support plate.
Figure 3
1. Heat shield
2. Align the heat shield with
these holes.
g421739
3. Mark and drill the holes
here.
3