Toro Z Master Professional 7500-D Series Installation Instructions page 2

Removing the Seat
Assembly
1. Slide the seat fully forward, then rotate the seat
upward.
2. Disconnect the seat wire harness from the main
machine wire harness.
3. Remove the cable tie securing the seat wire
harness to the seat-mount frame.
4. Lower the seat.
5. Remove the 4 seat-isolator nuts and remove the
seat from the frame
Retain the fasteners.
1. Seat-isolator nuts
6. Remove the fasteners securing the seat
assembly to the seat-support plate and
disconnect the prop rod.
Retain the fasteners.
7. Remove the seat assembly from the
seat-support plate.
(Figure 1).
Figure 1
2. Seat assembly fasteners
Installing the Kit
1. With seat-support plate facing upward, measure
and mark the location of the hole shown in
Figure 2.
2. Drill one 7 mm or 9/32 inch diameter hole at the
marked location.
WARNING
Using a drill without wearing eye
protection may allow debris to enter the
eye, causing personal injury.
When drilling, always wear eye
protection.
g436061
1. 24 mm (15/16 inch)
2
Figure 2
2. 9 mm (3/8 inch)
g424088