Functional Description - Milwaukee M18 FUEL 16GA Operator's Manual

FUNCTIONAL DESCRIPTION

1
10
9
8 7
12
1. Trigger
2. Handle
3. Hook
4. Power/Actuation
selection
5. Nail slot
6. Magazine
SYMBOLOGY
Volts
Direct Current
Single Sequential Actuation
Contact (Bump) Actuation
Read Operator's Manual
Wear Eye Protection
Keep Hands Away
UL Listing for Canada and U.S.
US
C
2
3
6
11
7. Pusher
8. Pusher release
button
9. Workpiece contact
10. Jam latch
11. Depth adjustment
12. LED
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
4
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Installing/Removing Fastener Strips
WARNING
Always wear safety goggles or glasses with side
shields.
Keep fingers clear of fastener track of magazine.
Pusher could pinch fingers, causing injury.
To install fastener strips:
1. Remove battery pack.
5
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Slide the fastener strip into the nail slot and down
toward the front of the tool. Be sure the point of the
fasteners is pointed downward. WARNING! Use
only recommended fasteners of the correct size,
length, collation angle, and head type as indicated
on the tool's nameplate. Other fasteners could
result in tool malfunction, leading to injury.
4. Press and hold the pusher release button and slide
the pusher back past the end of the fastener strips.
5. Continue to hold the pusher, but release the but-
ton. Slowly slide the pusher forward until it rests
against the fastener strip.
To remove fastener strips:
1. Remove battery pack.
2. WARNING! Always point the tool away from your-
self and others when installing fasteners. Failure
to do so could result in injury.
3. Press and hold the pusher release button and slide
the pusher towards the front of the tool. Release
the pusher.
4. Slide the nails back and out of the nail slot.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove the battery pack
any time the tool is not in use.
Only use accessories specifically
recommended for this tool. Others
Always remove battery pack before
changing or removing fasteners.