Table of Contents
Advertisement
5. Switching On and
Off
5.1. On or Standby
Make sure the display is connected to the mains AC
power. Connect the supplied power cord to the AC
in connector at the back of the display. The indicator
light at the bottom of the display lights up.
Switch on
Press
on the remote control to switch the display
on. You can also press the small joystick key on the back
of the display to switch the display on in case you can't
find the remote control or its batteries are empty.
Reboot
Long press
on the remote control for three seconds to
reboot the display.
Switch to standby
To switch the display to standby, press
control. You can also press the small joystick key on the
back of the display.
In standby mode, the display is still connected to the
mains power but consumes very little energy.
To switch off the display completely, disconnect the
power plug.
When disconnecting the power plug, always pull the
power plug, never the cord. Ensure that you have full
access to the power plug, power cord and outlet socket
at all times.
5.2. Keys on Display
If you lost the remote control or its batteries are empty,
you can still do some basic display operations.
To open the basic menu:
1 - With the display switched on, press the joystick key on
the back of the display to bring up the basic menu.
on the remote
13
2 - Press left or right to select Volume, Program or
Sources. Select Demo, to start a demo movie.
3 - Press up or down to adjust the volume or tune to the
next or previous program. Press up or down to go
through the list of sources, including the tuner selection.
Press the joystick key to start the demo movie.
4 - The menu will disappear automatically.
To switch the display on standby, select and press the
joystick key.
Advertisement
Table of Contents
