Subscribe to Our Youtube Channel
Related Manuals for HOMCOM 370-233V70
Summary of Contents for HOMCOM 370-233V70
- Page 1 INfnb001_UK 370-233V70 CHILDREN'S ELECTRONIC MOTORCYCLE IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY ASSEMBLY INSTRUCTION...
- Page 2 About your new vehicle On the purchase of your new ride-on. To ensure the user rides safely, please read these instructions carefully. Keep this manual for future reference. 100-240V 50/60Hz 0.3A 12V 1000mA 35W #550*2 ●Do not recharge non-rechargeable batteries. ●Before charging rechargeable batteries, remove them from the vehicle.
- Page 5 PREVENTING POSSIBLE INJURY OR DEATH: ● NEVER LEAVE CHILDREN UNATTENDED. ADULT SUPERVISION IS ALWAYS REQUIRED. Keep children in your view when they use this vehicle. ● A certain amount of skill is required when using this vehicle, preventing falls or collisions.
- Page 6 1. Insert the connecter on foot pedal R into the connector on the vehicle body. 2. Inert the tabs on foot pedal R into the groove on the right side of the body. 3. Insert the tabs on foot pedal L into the groove on the left side of the body.
- Page 7 Turn the ride-on upside down. 1. Place the wide wheel onto the vehicle body. 2. Insert Ø4x12 screws *6 and Ø4x30 screws *3, then tighten with a screwdriver. Place the ride-on upright. 3. Fit the rear foot pedal into the hole on the body – push until you hear it 'click' into place.
- Page 8 1. Remove a lock from the front axle with two spanners. 2. Place a Ø10 washer onto the front axle. 3. Slide the front axle through the hole on the right side of the front fender, and out of the hole on the right side of the handlebar fork. 4.
- Page 9 Attach the faceguard and handlebar 1. Plug the connector on the faceguard into the connector on the vehicle body. 2. Fit the tabs on the faceguard into the grooves on the vehicle body, then push until it is in place. 3.
- Page 10 1. Remove the screw on the top of the seat with a screwdriver, then remove the seat. 2. Plug the red connector on the vehicle body into the red connector from the battery, 3. Put the seat back.
- Page 11 1.Power button: Turn the unit on and off. 2. Foot pedal: ●To move the vehicle, press the pedal down. ●To brake or slow down, release pressure from the pedal. 3. Lights switch: Turn the front lights on and off. 4. Forward/reverse lever: ●To move the vehicle forward at high speed, shift the lever to top position.
- Page 12 AN ADULT MUST CHARGE THE BATTERY! This product has a charging protection: when charging, all functions will cut off. The power switch must be turned off when charging. ● Before first use, charge the battery for 4-6 hours. Do not recharge ●...
- Page 13 Battery is not fully charged. The maximum load has been exceeded. Check the battery connectors are firmly plugged into each other. If wires are loose around the Loose wires or connectors. motor, please contact the distributor. 'Dead spot' means the electric power is not being delivered to the terminal connection, which means the ride-on needs repairing.
- Page 14 ● It is the adult's responsibility to check main parts of this ride-on before using. It is important to regularly inspect the battery, charger, cable or cord and plug. Ensure screws are tightened. If any damages occur, do not use this ride-on until properly fixed. ●...
- Page 15 The battery has a thermal fuse with a rest fuse, which automatically cuts all power to the vehicle if the motor, electric system or battery overloads. The fuse will reset and power will be restored after the unit has been off for 20 seconds, the turned on.
Need help?
Do you have a question about the 370-233V70 and is the answer not in the manual?
Questions and answers