Table of Contents
Advertisement
The selected programme setting is
shown in the middle of the display.
Sub-menu
To select the settings you require,
press the buttons below the symbols
until the required setting is selected
in the display.
To select the settings you require,
press the buttons below the symbols
until the required setting is selected
in the display.
Before using for the first time en
If a setting is activated, the display
shows
. The selection does not
need to be confirmed again.
The sub-menu closes automatically
after a few seconds.
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press
.
1.
The switch-on process takes a few
seconds.
Set the ActiveOxygen Drum
2.
programme.
Clean
Close the door.
3.
Pull out the detergent drawer.
4.
19
Advertisement
Table of Contents
