Table of Contents
Advertisement
Fault
"E:30/-20"
The appliance is not
working.
The programme does
not start.
The door cannot
be opened.
Cause and troubleshooting
Do not add any extra water to the appliance while it
▶
is operating.
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed Start/Reload
Press Start/Reload
▶
Door is not closed.
Close the door.
1.
Press Start/Reload
2.
Childproof lock is activated.
→ "Deactivating the childproof lock", Page 35
▶
Finish in is activated.
Check whether Finish in is activated.
▶
→ "Buttons", Page 24
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Start/Reload
4.
is activated.
Rinse Hold
Continue the programme by selecting Spin or and
▶
pressing Start/Reload
→ "Resuming the programme when the programme
status is Rinse Hold", Page 35
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 35
▶
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 26
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 52
Troubleshooting en
.
.
to start the programme.
to start the programme.
.
45
Advertisement
Table of Contents
