Operation - Husqvarna X-SYNC Operator's Manual

To put the earmuffs in standby position
• Lift the earmuffs out and up until they lock in standby
position. (Fig. 15)
To put the earmuffs in parking position
1. Put the earmuffs in standby position. Refer to
the earmuffs in standby position on page 9 .
2. Turn the earmuffs rearward along the side of the
helmet until they lock in the parking position. (Fig.
16)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To charge the product
1. Connect the USB-C connector on the charger cable
to the outlet on the left earmuff. (Fig. 18)
2. Connect the USB connector on the charger cable to
a USB charger or other USB power outlet.
Note:
The output of the power outlet must be 5 V
and 2 A to charge at maximum capacity.
Note:
The LED indicator on the Bluetooth
flashes slowly green when the battery is charging.
The LED indicator on the Bluetooth
green when the battery is fully charged.
To start the product
• Push and hold the on/off button for 1 second.
Note:
A beep sound tells you that the product is
on. An audio message tells you the battery status
and the quantity of devices that are connected with
®
Bluetooth wireless technology.
Audio message
BATTERY HIGH
BATTERY MEDIUM
BATTERY LOW
BATTERY CRITICAL
2146 - 001 - 06.07.2023
To put

Operation

Before you operate the
®
button
®
button is solid
To connect the boom microphone
Use a boom microphone in environments with much
noise.
1. Attach the wind filter on the boom microphone.
2. Connect the boom microphone to the microphone
outlet on the right earmuff. (Fig. 17)
3. Put the boom microphone 1 cm/0.4 in. (A) from your
mouth.
Audio message
ONE BLUETOOTH DE-
VICE CONNECTED
TWO BLUETOOTH DEVI-
CES CONNECTED
To change between FM radio mode and
®
Bluetooth mode
• Push the mode button quickly 2 times to change
between FM radio mode and Bluetooth
Note:
An audio message tells you which mode
you have selected. Refer to the table below.
Audio message
RADIO
BLUETOOTH
FM radio mode
In FM radio mode you get access to FM radio.
To change FM radio station
• Push and hold the volume up button or the volume
down button for 1 second to change FM radio
station.
®
Bluetooth mode
®
In Bluetooth mode you can connect your product to a
®
device with Bluetooth wireless technology.
®
To do a Bluetooth
1. Push and hold the Bluetooth
to start the pairing operation on your product.
Note:
The pairing operation starts when you hear
a beep sound and the Bluetooth
blue. The pairing operation is on for 30 seconds.
LED indicator on the
®
Bluetooth button
LED is blue.
®
mode.
pairing operation
®
button for 2 seconds
®
button flashes
9