Transportation, Storage And Disposal; Accessories - Husqvarna X-SYNC Operator's Manual

1. Clean the product regularly. Use a cloth and a weak
soap solution.
2. Do a check of the condition of the sealing rings and
the foam rubber inserts before each use.
3. Replace the sealing rings and the foam rubber
inserts each 6 months or more frequently if it is
necessary. Make sure that the air hole on the sealing
ring points down during assembly. Use the original
hygiene kit that includes the sealing rings and the
foam rubber inserts. Refer to www.husqvarna.com
for more information about the hygiene kit. (Fig. 19)
Note:
If the earmuffs are wet on the inner side,
let them dry in parking position. Refer to
earmuffs in parking position on page 9 .
Transportation and storage
CAUTION:
storage, put the earmuffs in operation
position to decrease wear on the plastic
material.
• Put the earmuffs in operation position. Refer to
put the earmuffs in operation position on page 8 .
• Make sure that the sealing rings are not
compressed.
• Put the product in a dry and clean space.
• Keep the product away from sunlight during storage.
• Charge the battery each 6 weeks to keep the quality
of the battery.
Approved helmets
Use the product with the helmets below only.
Model
Husqvarna Technical,
H300
Husqvarna Spire
KASK Zenith X
2146 - 001 - 06.07.2023
To put the

Transportation, storage and disposal

During transportation and
To

Accessories

Helmet attachment type
Adapter H300
Adapter Spire
4. Replace the membrane for the speech microphone if
it is damaged.
5. Replace the wind filter for the level dependent
microphone if it is damaged.
6. Replace the wind filter on the boom microphone if it
is damaged.
7. Replace the Comfort Pad of the headband if it is
necessary. (Fig. 20)
• Put the product in a safe space during
transportation.
Disposal
• Obey national regulations.
• Use the local recycling system.
• The product or package of the product is not
domestic waste. Recycle it at a recycling station for
electrical and electronic equipment.
Adapter graphic
(Fig. 21)
(Fig. 22)
Approved dimensions
M/L
L
11