Advertisement
LED FUNCTIONS
OF CHARGER
LED WILL BE ON
TO INDICATE STATUS OF CHARGER
AND
BATTERY
PACK:
•
Red LED on = Fast charging mode.
•
Green LED on = Fully charged and In trickle charge
mode,
•
Green LED on = When bakery pack is Inserted Into
charger, indicates hot battery pack or that battery pack
is out of or below normal temperature range.
•
Yellow and Green LEDs on = Deeply discharged or
defective battmy back.
•
No LED on = Defective chargeror battery pack.
,_
CAUTION:
To prevent damage to battery back,
remove battery pack from charger Immediately If no
LED comes on. Return battery back and charger to
your nearest Sears Service Center for checking or
replacing,Also, if you are removing battery packfrom
charger and no LEDs are on, return both battery pack
and charger to your nearest Sears Service Center,
Do not Insertanother battery pack Into charger. A
damaged charger may damage a battery pack,
TO INSTALL OR REMOVE BATTERY
PACK
See Figure2.
•
Use only the recommended battery pack with your light.
WARNING:
Do not install battery back to your light
untilyou have read and understoodall ixecautions
and operating InstructionsIn the manual and printed
on battery pack and charger,
II
Orient battery pack so that raised rib on battery pack
aligns with groove Inside light. Battery pack is de-
signedto fit only one way Into light handle,
•
Insert battery pack, making sure latches on each side
of battery pack snap Into place and battery pack is
secure In light before use.
A
CAUTION: When placingbattery pack In your light,
be sure raised ribon battery back aligns with groove
Inside lighthandle and latches snap Into place
properly.Improper assembly of battery pack can
cause damage to Internal components.
•
To remove battery pack, locate latches on end of
battery pack and depress to release battery packfrom
your light.
SWITCH
See Figure 3.
To turn lighton and off, depress switchtrigger.
SWffCH
LATCHES
Fig. 3
HANGING I STORAGE
FEATURE
See Figure 4.
On top of the housing Is a hook In which you can use to
hang the light up. This Is a good feature for stodng light
when not In use and also to keep lightout of the reach of
children. To use, simply lift up on hook.
TO
RAISE
HANGER
TO
BATrERY PACK
Fig. 2
Flq 4
Advertisement
