Table of Contents
Advertisement
en Installation instructions
Fit the two plastic covers on the left and right of the
7.
profile.
Insert the power cable into a protective contact
8.
socket.
The power cable must not touch the rear and base
of the appliance after installation.
Adjusting the appliance front
Adjust the appliance front upwards or downwards if ne-
cessary.
Open the appliance.
1.
Undo the screws on the side of the front panel.
2.
Align the appliance front upwards or downwards.
3.
Alignments of maximum -3 to +3 mm are possible.
Tighten the screws.
4.
Combining the warming drawer with another
appliance
ATTENTION!
Sharp edges on the appliance may damage the front
panel of the warming drawer.
Do not damage the front panel of the warming
▶
drawer when sliding the appliance in.
Only combine suitable appliances of the same
1.
brand and series.
2.
Install the warming drawer first.
Slide the appliance, on the warming drawer, into the
3.
built-in cabinet.
Note the installation instructions for the appliance.
4.
20
Advertisement
Table of Contents
