Haier HWM120-B1678S8 User Manual page 14

Control Panel
Press the "Power" button to switch on/off the washing machine.
IThe washing machine will switch off automatically if the "Start/Pause" button is not
press within 10 minutes.
The function is intended for children safety and preventing children change the washing
program.
Activate the Child Lock function:
First press the "Power" button and select the desired washing program and press the
"Start/Pause" button. Next press the button "Progress" and "Delay" for 3 seconds
simultaneously to lock all the button. You will hear 3 beeps. After the 3 beeps, the display
shows "CL" means child lock function is activated.
Deactivate the Child Lock function:
Press the button "Progress" and "Delay" for 3 seconds simultaneously again and after 3
beeps, the child lock light turn off and child lock function is deactivated.
Note: If you open the lid when the Child Lock function activated, display shows "E2" with the
beep, please close the lid and press the "Start/Pause" button to cancel it. Otherwise the
washing machine will drain after 10 seconds, and off after 10 minutes.
Press the "Function" button to select the Tub Dry function. The purpose is to dehydrate the air
from the outer tub and inner tub, which can avoid growing mildew on the outer and inner tub.
Press the "Function" button to select the Air Dry function. The purpose is to facilitate faster
drying the laundries at a maximum load capacity 2.5kg. Air Dry function couldn't support
under the Delay mode.
Press the "Function" button to select the Reserve function. The water will retain inside the tub
up to 4 hours. The appliance will send an alarm every 15 minutes to remind the user about
the rinse water that kept inside the tub. You may press the button "Start / Pause" to allow the
rinse water to drain out from the tub. Otherwise, the water will drain out from the tub
automatically once the time's up. Reserve Water is not applicable for program Wool,
Tub Clean, Soft Wash and Tub Dry function.
Adjust the water level by choosing the desired water level if required, then press the
"Start/Pause" button.
If there is water inside the tub and the machine couldn't detect the laundry load, it will display
water level at "Mild".
If putting in wet laundries inside the tub, it will display water level at "Mild" and you may adjust
the desired water level if required.
If Express program is selected, it will display water level at "Low" and you may adjust the
desired water level if required.
If Tub Clean function is selected, water level couldn't be adjusted.
The actual water level inside the tub may vary from the water level indicated on the control
panel. This is subject to the clothing dampness condition which is inside the tub.
12