Maintenance And Cleaning - Beko WCV9614XB0STW User Manual

C
INFORMATION
• Depending on the step where the
programme was canceled in, you may have
to add detergent and softener again for
the programme you have selected anew.
4.3.17 End of programme
At the end of the programme, "End" will be
displayed.
1. Wait until the light of the loading door goes
off completely.
2. Press the On/Off button to switch off the
machine.
3. Take out your laundry and close the loading
door. Your machine is now ready for the
next washing cycle.
4.3.18 Your machine has the
"Pause Mode" function.
After using the On/Off button to switch on the
machine, if you do not start any programme
in the selection step or do not perform
anything else, or if you do not do anything in
10 minutes after the selected programme has
ended, the machine will automatically switch
to energy saving mode. Also, if your product
has a display that shows programme time,
this display will completely turn off. If you turn
the Programme Selection knob or touch any
button, the lights and the display will switch
back to the previous position. The selections
you make when exiting the energy efficiency
mode may change. Check if your selections
are correct before starting the programme. If
necessary, make adjustments again. This is not
an error.
19 / EN

4.4 Maintenance and cleaning

Service life of product extends and frequently
experienced problems will be reduced if it is
cleaned at regular intervals.
4.4.1 Cleaning the detergent drawer
Lift the rear part of the siphon to remove it as
illustrated.
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
1 Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
2. Wash the detergent drawer and the
siphon with plenty of lukewarm water in a
washbasin. In order to prevent the residues to
contact your skin, clean it with an appropriate
brush by wearing a pair of gloves.
3 Insert the drawer back into its place after
cleaning and make sure that it is seated well.
4.4.2 Cleaning the loading
door and the drum
For products with drum cleaning programme,
please see Operating the product -
Programmes.
C
INFORMATION
• Repeat Drum Cleaning process
in every 2 months.
• Use an detergent / anti-limescale
suitable for the washing machines.
After every washing
make sure that no foreign
substance is left in the
drum.
Washing Machine / User's Manual
Clean the detergent
drawer at regular intervals
(every 4-5 washing cycles)
as shown below in order
to prevent accumulation of
powder detergent in time.