Starting The Programme - Beko WCV9614XB0STW User Manual

To enable Child Lock:
Press and hold the Auxiliary Function button 2
for 3 seconds. While you're holding the button
pressed for 3 seconds, C03, C02 and C01 will
be displayed respectively. Then, while the light
of the Auxiliary Function Button 2 is flashing,
"Con" will be displayed, indicating that the child
lock has been enabled. If you press any button
or turn the Programme Selection knob while the
Child Lock is enabled, the same warning will be
displayed.
To disable Child Lock:
Press and hold the Auxiliary Function button 2
for 3 seconds while the programme is running.
While you're holding the button pressed for 3
seconds, C03, C02 and C01 will be displayed
respectively. Then, while the light of the
Auxiliary button 2 is flashing, "COF" will be
displayed, indicating that the child lock has
been disabled.
C
INFORMATION
• In addition to the method above, to
deactivate the Child Lock, switch the
Programme Selection knob to On/Off
position when no programme is running, and
select another programme.
• Child Lock will not be disabled after
a power failure or unplugging.
4.3.11 - End Time Adjustment
The End Time Adjustment function allows you
to set the end time of the programme up to 19
hours. You can increase this time by 1-hour
intervals.
C
INFORMATION
• Please do not use liquid detergent if you
have selected the End Time Adjustment
function. Stains might remain on the clothes.
1. Open the loading door, place the laundry
and add detergent, etc.
2. Select the washing programme,
temperature, spin speed and, if required,
the auxiliary functions.
3. Press the End Time Adjustment button and
select the desired time.
4. Press the Start/Pause button. The delayed
end time you have set will be displayed.
Countdown will start for delayed end. On
the display, "_" will move up and down next
to the delayed end time.
17 / EN
C
INFORMATION
• If the programme has not started,
you can add laundry into the machine
during the delayed end time.
5. At the end of the countdown, duration of
the selected programme will be displayed.
"_" will disappear and the selected
programme will start.
Changing the delayed end time
If you want to change the time during countdown:
1. Press the End Time Adjustment button.
When pressed for the first time, the
programme duration will be rounded up
to the closest whole number time. Each
following press will increase the time by an
hour.
2. If you want to decrease the delayed end
time, press the End Time Adjustment button
consecutively until the desired time is
displayed.
Cancelling the delayed end function
If you want to cancel the delayed end
time countdown and start the programme
immediately:
1. Press the End Time Adjustment button
until the Delayed End time is equal to
the selected programme time, or set
the Programme Selection knob to any
programme. This way, the Delayed End time
will be cancelled. The End/Cancel light will
flash continuously.
2. Then, select the programme you want to
run again.
3. Press Start/Pause button to start the
programme.

4.3.12 Starting the programme

1. Press Start/Pause button to start the
programme.
2. Programme follow-up light showing the
startup of the programme will turn on.
C
INFORMATION
• If no programme is started or no key is
pressed within 10 minutes during the
programme selection process, the display
lights will go off. Once the Programme
Selection knob is turned or any button is
pressed, display lights will turn on again.
Washing Machine / User's Manual