CARTON
CONTENTS
The tollowing parts are shipped loose with your
cleaning system:
•
Main Unit -- pressure washer with wheels,
chemical tanks, guide handle.
•
High Pressure Hose (already attached to pump)
•
Parts Box (which includes items listed below)
•
Spray Gun
•
Wand Extension with Hi/Lo Adjustable Nozzle
•
Engine Oil
Three-pack of chemical concentrates
•
Manual Bag (which includes the items listed
below)
•
Owner's Manual
•
Nozzle Cleaner Kit
•
"O"-Fling Kit
•
Tank Labels
Become familiar with each piece before assembling
the cleaning system Check all contents against the
illustration on Page 5 If any parts are missing or
damaged, call the Pressure Washer Helpline at
1-800-222-3136.
TO REMOVE
PRESSURE
WASHER
FROM
CARTON
•
Remove loose parts and parts box included with
your cleaning system.
•
Slice two comers at guide handle end of carton
from top to bottom so the panel can be folded
down flat
Uft the handle to
upright position and
slide the locking
caps into place
•
Raise guide handle, secure in place.
Roll the cleaning system out the open end of the
carton.
•
Check carton for additional loose parts
HOW TO SET UP YOUR PRESSURE
WASHER
For the most part, your Craftsman High Pressure
Cleaning System has been assembled at the factory
You must, however, assemble the spray gun, and
attach the high pressure hose to the spray gun
•
Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun Tighten by hand
•
Attach nozzle extension to spray gun
Place assembled spray gun on holder
4