Table of Contents
Advertisement
6. CONNECTION
Connect the pC to the outdoor unit's pCB via the
Communication control box (ma306 manufactured
by micro application).
there are three types of connectors on the control
pCB.
Choose the cable required based on the three
types listed below:
type1 : pa connector -6 pin
type2 : pa connector -10 pin
type3 : pa connector -12 pin
* When there is no connector on the control PCB.
the connector for communication may not be soldered onto the control pCB.
in this case please use the following connector:
Connector
manufacturer
JSt
Caution
you must turn off the power supply, before mounting the connector on the control pCB.
(there is a possibility of electric shock.)
please make sure the boss lines up with the locating point on the pCB.
Please be cautious when connecting the connector as it can cause damage if not fitted
correctly.
Copyright© 2013-2016 Fujitsu General Limited. All rights reserved.
Communication
control box
uSB cable
model number
B10B-paSK-1
boss
you must turn off the power and
wait 5 min. before you connect or
remove the Communication con-
trol box to the Control pCB.
Cable for control pCB(type1/2/3)
Control pCB
of outdoor unit
location point
WARNING
En-10
Advertisement
Table of Contents
