Advertisement
Available languages
Available languages
INTRODUCTION
Thank you for buying our product. Please read through these operating
instructions, so you will know how to operate your equipment properly. After you
finished reading the instructions manual, put it away in a safe place for future
reference.
Outdoor Sensor
C1: Transmission Indication LED
C2: Temperature display
C3: Humidity display
C4: Wall mount hole
Getting Started
Batteries compartment of thermo sensor is locating behind the back cover. Insert
2 x AA batteries observing polarity ["+" and "−" marks]
Installation
The remote sensor should be placed onto flat surface or securely mounted onto a
horizontal surface.
Note: Transmissions between receiver and transmitter can reach up to 70 m in open area.
Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high voltage
lines, etc
The use of 1,5 m cord Temperature Probe
• Insert the probe plug into the jack on the outdoor sensor.
• Put the cable outside and leave the Thermo Sensor Unit indoor to avoid freezing
up the battery when the outdoor temperature is below −20 °C.
• Always use the temperature probe to sense the temperature when the
temperature is between the following range: −50 °C ~ 0 °C and +50 °C ~ +70 °C
Specifications
433,92 MHz RF transmitting frequency, ERP 0,104 mW
C5: "RESET" button
C6: Battery compartment
C7: Cable probe
EN - 7
Advertisement
