Installation Location; Electrical Connection; Water Supply Connection - Kaffit X Series Manual

�.� Installation location
�. The installation location must be dry and protected against water spray
�. Some condensate, water, or steam can always be discharged from a coffee
machine
�. Do not use the coffee machine outdoors.
�. The machine has to be installed on a solid, level and heat-resistant base.
�. The surrounding temperature must be between �℃~��℃.
�.� Electrical connection
�. The mains connection must correspond with the voltage, amperage and
frequency indicated on the machine label.
Installation of wrong or improper electric plugs can cause short circuit
resulting in fire. The plug has to be selected and installed by qualified service
personnel only.
�. The X� series are electrically safe only when properly earthed as described in
the current electrical safety specifications. Check for compliance and, when
in doubt, have the wiring thoroughly inspected by skilled personnel.
�. The manufacturer does not take any responsibility for any damage caused
by incorrect earthing or improper use of power supply .
�. No action needed from users to shift the product between �� and ��Hz,
product can adapt itself for both �� and �� Hz.
�.� Water supply connection
Tank water supply, tap water supply and barreled water supply are available
for the X� series. Tank water supply and tap water supply are the standard
configurations when the factory setting has been finished. Default water
supply is water tank.
�.�.� Water quality
Total hardness：
Carbonate hardness
Acid content/pH value
Chlorine content
TDS
electric conductivity
Iron content
To guarantee the required water quality,a water filter system needs to be
installed
� ‒ � dH GH
�� ‒ ��� ppm (mg/l)
�‒� dH KH / ��‒��� ppm (mg/l)
�.�‒�.� pH
< �� mg/l
�� ‒ ��� ppm (mg/l)
��‒��� μS/cm (microsiemens)
< �.� mg/l
13